Friday, April 25th 2014, 2:16am UTC+2

You are not logged in.

  • Login

Dear visitor, you are currently not logged in. Login or Register as a new user .

KennaOkoye

Unregistered

1

Thursday, May 10th 2012, 10:54am

Patch editing insight!!!!

Okay I noticed some patches on the virus are rather WIDE stereo image wise. Some simply are not! What's responsible for making it wide I can't for my life figure it out.....is it unison. I would like to make certain patches wide quickly within thhe virus. How do I do so?

2

Thursday, May 10th 2012, 3:06pm

The sensation of wideness is caused by your left and right ears not receiving the exact same sound, with slight differences in character, volume, pitch and phase.

  • The "stereo widener" in the character section of the FX1 tab, does complementive EQing to the left and right channels.
  • You can do continouos rapid panning to the sound.
  • Spreading the unison, using chorus and other delay based effects will give you phase and pitch differences between left and right. The Leslie speaker simulation will also add panning.

KennaOkoye

Unregistered

3

Friday, May 11th 2012, 2:51am

Thank you sir!
I think it's spreading the Unison? how can this be done?

honestly it sounds like one osc is panned one way and the other is panned another way... Kinda like in sylenth... thats how i would achieve this...

4

Friday, May 11th 2012, 9:58am

In VC the unison controls are in the LFO section, and there is a spread knob there. You can also change the filter routing to "split" so that some of the oscillators would go through one filter to the left channel, and the other oscillators would go through the other filter to the right channel. You can control the amount of separation in this case using the very same unison spread knob.

KennaOkoye

Unregistered

5

Saturday, May 12th 2012, 6:36am

Do u know where this spread knob is on the actual board not VC

6

Saturday, May 12th 2012, 10:28am

There isn't a dedicated knob for this. The unison spread can be reached from the single edit menu, Unison 1/1 page, Pan Spread value. The same way, filter routing can be changed from the filter edit menu, Common 1/2 page, Routing parameter.

KennaOkoye

Unregistered

7

Monday, May 14th 2012, 8:11pm

Thanks man!

KennaOkoye

Unregistered

8

Monday, June 11th 2012, 9:39am

How do I access stereo widner character section on the hardware?? Thnx

9

Monday, June 11th 2012, 1:03pm

It's in the EFFECTS section, use the lower select button to highlight CHARACTER press the edit button then turn soft knob 1 under Type to the selection required.

KennaOkoye

Unregistered

10

Monday, June 11th 2012, 8:33pm

Thank you!