Automation Problem In Logic 9.1.7

  • Hi Folks,


    I'm simply automating the Filter 1 cutoff of a patch, automation recorded by moving the cutoff knob on the VC.


    The problem is when the track loops around the cutoff dial is not resetting to the value of the node on the automation track, I have to grab the mouse and move the cutoff knob on the VC and then it 'remembers' where it should be.


    Anyone know if this is a problem with the current version or is Logic somehow not sending the automation info back to the VC on loop around? I've got it in read mode of course.


    Cheers.

  • Thanks Marc,


    I had a node at the beginning of the bar, however this was the same value as the other nodes before the automation for the cutoff ramped up, however by changing the value + or - 1 at the start of the bar did the trick.


    Cheers.