Hey guys i just got my Virus TI snow some days ago
Today i had some time to mess with it.
i was creating a patch and when i wanted to assign filter 2 cutoff parameter to one of the three knobs i have on the TI Snow i found out that this parameter is not listed in the Destination menu.
am i missing something 
Any help would be appreciated.
Thanks
You can assign one of the softknobs to the Filter 2 Cutoff
Hope that helps
Cheers
If it's not called "filter 2 cutoff" then it is called "filter 2 frequency", or simply "filter 2". It must be there.
these are the options i have.. no Filter 2 cutoff , no filter 2 freq, no filter 2 offset
[Blockierte Grafik: http://i471.photobucket.com/albums/rr78/terranoise/VirusTIoptions.jpg]
You can assign one of the softknobs to the Filter 2 Cutoff
Hope that helps
Cheers
can you explain how please? 
OK, I stand corrected. Maybe I never needed it because I don't own a snow? And doesn't the snow have two extra knobs on the right for this?
Anyway, you can overcome this by assigning the softknob to a controller, and in the modulation matrix, assign this controller to filter 2 cutoff frequency.
OK, I stand corrected. Maybe I never needed it because I don't own a snow? And doesn't the snow have two extra knobs on the right for this?
Anyway, you can overcome this by assigning the softknob to a controller, and in the modulation matrix, assign this controller to filter 2 cutoff frequency.
the two extra knobs on the right assigned to the filter cutoff 1 and to the resonance of that filter 1.
thanks for the advice the workaround works perfectly
