Is there a way to use the additional envelopes to control the oscillator amplitudes independently?
I've tried routing them via the matrix but the 'master' AMP envelope always seems to take precedence.
Tx!
Is there a way to use the additional envelopes to control the oscillator amplitudes independently?
I've tried routing them via the matrix but the 'master' AMP envelope always seems to take precedence.
Tx!
You can do that, It's just that because you control mix volume and balance, you'll have to think like when you're doing mid/side processing, for example, if you want osc1 to go /\_ and osc2 to go _/\, then the osc mix volume should be /¯\, and the balance should move gradually from osc1 to osc2.
Hope this helps.
What a devilishly ingenious way to think about it.
So in my specific case I wanted:
OSC1:
|\___
OSC2:
_____
|
So I start with my OSC balance in the middle and immediately cross fade to OSC22 so that only OSC2 is in the mix at the point OSC1 hits the end of it's decay. ..and in fact I should be able to accomplish this by routing the envelope for OSC1 to the OSC mix in the matrix.
Brilliant! Thank you!