ChannelPressure Does Not Function in Virus Control

All-
I have a couple of patches that I have mapped Channel Pressure ->LFO 3 Assign Amount (Vibrato). I have saved these patches to a RAM bank and they work fine.

However, if I load the patches from the same RAM bank inVirus Control, the channel pressure has no effect, even though the parameters remain correct in the software editor.

All of the other sources can be selected within the matrix and work normally.

Any assistance appreciated.

-dj

I have no Midi filters enabled.

I also saw a reference to this problem on this forum from 2010 using Pro Tools as well, so it looks like it has been an issue for a while:

http://virus.info/forum/index.…ighlight=channel+pressure

-dj

FB-

If you are suggestion to add the Aftertouch to the track after it is played into Pro Tools, I have not tried that. I will let you know, but that would seem an unnecessary step to have to take, as the hardware should respond in real time. As I mentioned, all the other controllers work fine except aftertouch.

Thanks-

-dj

Most appreciated, will check it out.

-dj