FCB 1010 foot controller - change program in VIRUS TI2 (Single mode)

Hello all,

I am asking if anyone has experience in using the FCB 1010 foot controller device to control the VIRUS TI2 program changes by midi?

I tried to change programs in Single Mode of VIRUS TI2 by using the foot knobs of the FCB 1010 , but it worked not 100% successfully. Before that I used a software to set up the FCB 1010.

Problem:

My problem is that the the "midi change number" in the virus is somwhow shifted by -1. That means if I send a midi message by the FCB 1010 e.g. change to program 50, the virus will change to program 49...

Can anybody give me any advice how I can solve that?

I also thought about the possibility to send a "midi program change message" with the FCB1010 by channel +1, so that "change program to 51" becomes 50 in the virus, but maybe there exist a better way to do that.

Regards Christoph Clemens

Hi flabberbob

Thanks for the answer. I checked if I can change
my devices (motif rack and virus ti2 and fcb1010) to the other Midi Mode, but i couldnt find any Setting to do that except for the fcb 1010 programming software.

The fcb Foot Controller software can send in 0-127 or in 1-128 Mode.
As far as i understand i need to change the Virus or the Motif Rack into another
Midi Mode, because at least one device is Not in the correct Mode.

Do you know where i can do that for the Virus ti2?

Greets Christoph