Just want to confirm that if I configure the Pan setting for a patch for center 0/0, then the output of both Analog 1 and 2 will be the same, essentially a mono signal. I want to send a mono signal to my line mixer when playing live.
Thanks-
-dj
Just want to confirm that if I configure the Pan setting for a patch for center 0/0, then the output of both Analog 1 and 2 will be the same, essentially a mono signal. I want to send a mono signal to my line mixer when playing live.
Thanks-
-dj
The oscillators themselves are mono, but unison with pan spread, and some of the effects such as ping-pong delay send separate signals to the out pair. Your best bet is to set the output to 1L or 1R (not 1R+L), and feed a mono channel in your mixer with it using a single cable from the Virus.
BTW some mixers allow you to mix stereo to mono if you keep the pan-pot of every mono channel in the middle position.
Hope this helps.
Thanks, Bob.
Appreciate the input.
My Ashly line mixer would do that, but I will try the single cable solution first.
-dj