Hi All!
I just switched from a Virus C to a TI and I'm having trouble figuring out how to do something. On the C, In Multi Mode, I could route the output of one part to the input of another by setting the output to one of the internal auxes, and then setting the input of the next part to that aux. This was extremely useful for certain effects chains like (audio input>chorus>filter) or routing the delay/reverb block to a post filter.
On the TI, If I go into Multi Edit for a part, all I see under 'Output' are the hardware outs - where are the internal auxes hiding?
Thanks!
Brendan