Access TI Snow Stuck in USB Update Mode

  • Hey,


    I am not sure if anyone else has had this issue.


    I am running a Snow on 5.1.1 and just updated my PC and the latest TI VST requested the Virus OS be updated. However when I try it gets stuck in USB update mode V2.08 and then the computer can't find it and a communication error comes up in the Access Control Centre, then I have to power off the Snow and turn it back on, and then it's a loop from there.


    I have tried to update it on the old computer, however I was unable to have any more luck there than the new computer.


    I am hoping there is an easy fix. I sent an email to support and didn't get a response so I hope it isn't one of those things that is too hard.


    Thanks in advance to anyone who can help.


    Best regards

    James