agree, they should have included an on/off switch. But no, Access thought it was more important to include a silly demo song as part of the permanent interface.
Virus TI no Audio
-
-
agree this is the only synth in my setup that lacks an off and on switch.
-
I had the same issue for months. The only way I was able to get the outputs to work was to follow these steps
1. Disconnect the USB cable from the TI
2. Disconnect the power cable from the TI
3. Disconnect the power cable from the power outlet
4. Reconnect the power cable to the TI
5. Reconnect the power cable to the power outlet
6. Reconnect the USB cable to the TI
7. Press and hold the ARP EDIT button for a few seconds (I usually do it for at least 10) and then let go -
found this
it is about VIRUS B but maybe something helps
-
Do you get audio when you play the demo song (top left buttons next to volume pot)?
Hi Abraxa,
I also have the No Audio issue... But I can get sound if I play the Demo (it also plays sound for about 3 seconds when switched on then stops)...
Any ideas how to solve this?
Best wishes
Matt
-
Thanks kazeko! Good to know! I have my TI2 plugged into a power strip with other hardware also plugged into it. When I'm through with a session I put my TI into Standby but then turn the power strip off too, so that's good. I agree, they should have included an on/off switch. But no, Access thought it was more important to include a silly demo song as part of the permanent interface.
Cheers!
PS. Don't forget, even if you leave your TI in Standby, or disconnect the PSU from the unit, the PSU itself is still on and running if it is plugged in to the wall or a power strip that is left on.
i was wondering if dimming the panel LED's is not putting extra strain on voltage regulators as well?
since it needs to switch it on and off very quick ,so i guess it can also wear down regulators...
food for thought...
-
> i was wondering if dimming the panel LED's is not putting extra strain on voltage regulators as well?
No, it reduces the load by a tiny amount actually.
-
> i was wondering if dimming the panel LED's is not putting extra strain on voltage regulators as well?
No, it reduces the load by a tiny amount actually.
good to know,thank you for replay
-
-Did a hardware check within the Virus self test
how you start Virus self test ?