Hello, all. I am using a Virus B (which i purchased used) and i have been having a lot of fun designing single patches. I've saved a couple of multi patches, but I can't figure out how to switch between them. I can't find the answer in the manual (I've been searching for days). My intention is to switch from one multi patch to another via midi cc #32 sequenced from my Digitakt. Can someone please walk me through switching between multimode patches, and how to automate this via midi? t
Switching between multimode patches? Please help!
-
From memory, you have to send the Virus not a CC but a SysEx -
For SINGLE Mode:
But, for MULTI Mode, i have find nothings
-
For SINGLE Mode:
But, for MULTI Mode, i have find nothings
Hi, find attached a file I received from the Access support team. So I am sure it is not a secret I share here, but a valuable information source for "deep divers" like me.
I used it for programming my Bitstream 3x. It is a complete midi data sheet with all valid CCs and Sysex's.
Unfortunately was I not able (might be I make a mistake somewhere....) to switch Multis. The Bitstream would be the perfect companion, as it can have 20 programs which is more than the 16 Embedded Multis (0-15). The Referenced Multis (16 - upwards....) are only mentioned once in the attached file - at the end.
-
Hi, find attached a file I received from the Access support team. So I am sure it is not a secret I share here, but a valuable information source for "deep divers" like me.
I used it for programming my Bitstream 3x. It is a complete midi data sheet with all valid CCs and Sysex's.
Unfortunately was I not able (might be I make a mistake somewhere....) to switch Multis. The Bitstream would be the perfect companion, as it can have 20 programs which is more than the 15 Embedded Multis (0-15). The Referenced Multis (16 - upwards....) are only mentioned once in the attached file - at the end.
Whao !!! Exellent THANKS
If you find the solution, tell me please....
For CC here, and more:
-
signofthejoker in my sequencer I use PC <multi #-1> without setting MSB:LSB. It works 100% reliably if the Virus is in multi mode.
Mine is a Virus TI2. I have not looked at the documentation to be sure Virus B is the same, but I would be surprised if it were different.
-
How do I delete a post?
-
Go on, EDIT/ Select all your text / delete / SAVE
