Is it possible to edit Sub Oscillator on hardware?

Hi,

I have a TI2 and I am looking for the option to change the waveform of the sub-oscillator on osc 1, but I can't find it directly on the synth (hardware); when I hit "edit" on the oscillator section, I do not have such option and when I hit again "edit" there is only a "noise" page (+ a few extras on osc 2).

Do you know where I can find this? Is it possible??

Thanks for your time!

Cheers

Hi,

I don't understand, I can't find the "common 1/2" page.

In the oscillator section, on osc1, when I hit "edit", I have "Oscillator 1 1/2". When I hit "edit" a second time, I have a single "Noise" page, no "Common 1/2".

I am using version 5.1.7.00.

Est-ce que je rate quelque chose ? Merci pour ton aide !!

Hi, thanks again for your help but I still can't find this "common 1/2" page.

On osc 1 or 2, in Mode "classic" (as you can see in the previous picture), trying several "shape" and "wave select"/"pulse width", I still can't get access to a single sub oscillator option when I hit "edit" again...

When I hit "edit again, I only have a single "Noise" page.

Is there some kind of option in general Config or Edit that could have an effect on having access to the sub oscillator?

I have checked the documentation but didn't find any clue except that you are supposed to be able to choose between square & triangle in classic mode...

Hi again, thank you so much for taking the time to make pictures, I really appreciate it!!

But I still do not understand: when, on osc1 I hit "Edit" I go to the "Noise" page, I have never seen the "Common" & "Sub Ocsillator" pages...

I just tested again and I have the same result...

Quote from Lioio

here

To go from pic 1 to pic 2, and 3, you only hit the "Edit" button that is located under in the oscillator 2, correct?

Quote from oliAtBass

djenzar you can use the PARAMETERS buttons to navigate between the pages for Common1/2, Common 2/2, Noise, Ring Modulator and Sub.

If you don't know how to navigate parameter pages on the hardware, you probably missed a lot of the Virus functionality. The function of the PARAMETERS buttons can also be configured in EDIT CONFIG System 5/6 to either switch through pages or switch through parameters.

OMG, this was it! I didn't use the parameter button on the "noise" section!!

I use it a lot but I didn't know about this page and I was stuck on the noise page...

Sorry, I am still new with this synth!

Thank you so much guys!!

https://media.giphy.com/media/…S9LZJ/giphy-downsized.gif