Beiträge von justinmichael

  • Communication Error

    Hi,


    Below are all the details about my system.


    2 x 2.66 Ghz Dual Core Intel Xeon
    5 GB 667 MHz DDR2 of Memory
    Mac OSX 10.5.8
    Logic 9.02


    Virus TI Version: 3.3.4.00
    Virus TI Control Version 3.3.4.00
    Audio Driver Version 2.0.3.0


    Audio Library Version 2.0.3.0
    Host Interface Version 2.0.3.0
    Midi Driver Version 1.5.0.0


    Thanks!
    Justin

  • Communication Error

    I started receiving an error when loading up the Virus TI Plugin on Logic 9.


    It says - "A Communication error has occurred. The Virus TI does not respond to request messages or the transmitted data is corrupt. Please be aware that the RAM banks in the browser window will not correspond to the actual content in the device! Please check your system setup."


    Please advise what I should do to fix this problem?


    Thanks,
    Justin

  • Using the USB and Outputs 1-2 at the same time.

    Marc,


    thanks for this info.. but can you please advise me how i can play them at the same time.


    Example: Using total intergration plugin on logic 9 to select a patch and create my pattern (midi), and then using outputs 1-2 to then bounce my selection track to audio.


    How can I achieve this?
    My Virus TI Polar plays audio through USB even if my 1/4 inch cables are not connected to output 1-2.
    Is there a setting to change this?


    thanks,
    Justin

  • Using the USB and Outputs 1-2 at the same time.

    Hi, I have a question for all the virus ti polar experts out there.


    Is it possible to use the Virus Ti Polar with the USB plugged in (plugin synth) and use the outputs 1-2 at the same time?


    I am trying to use it as the plugin synth, but at the same time be able to get sound out of outputs 1-2 so I can run it through some outboard pre-amps.
    I haven't been able to figure out how to do this, or if its even possible.


    Thanks!
    Justin