Beiträge von JeffCoulter

Hello,

I bought my TI used a couple of years ago and have been really digging it.

I tend to setup MULTIs and assign the outputs so I can use different effect sends of my mixer for some sounds.
I started to find that a couple of months ago it was not really correctly memorizing my output assignments.
I would call up the output assignment page and there is was set to 3LR but it was coming out of 1LR until I turned the
adjustment knob to the assigned output and then it was working correctly.
This was a pretty consistent ongoing glitch.
Then today I fired it up and it was hung on the WELCOME screen.
I unplugged and re-plugged the power cord and it booted up, but... all my MULTIs are gone and the RAM banks are all empty.

I'm going to replace the battery tomorrow and then find out when I did the last backup in MIDIQuest.
But I am wondering if the output assignment issue was a warning that the battery was getting low?
I didn't really find any other problems, at least I did not notice anything in particular, but the output issue was getting quite annoying.

Thanks for your time.
Be Well.
Jeff

I know this thread is ages old, but I just got my first Virus {TI Rack] and am astill going through all the patches - I would have thought that this was already a feature, but like some other users, my Virus is not immediatly reachable and it would be incredibly useful to have this feature. I realize that these knobs can be mapped to anything, but with all the unused MIDI CCs it seems a natural setup to have these mapped to he Soft Knobs and then mapped to the selected paramter. I also get that this is an extra layer of translation the synth must perform, but I am just putting in a vote for this.