Pops and Clicks Problem in Multi-Mode

Hi,

I hear pops, and click from my Virus Ti keyboard when I'm playing a program, or multiple programs in Multi-mode, I'm not using it via USB, it is just in stand-alone mode, using analog outputs 1-2, local is 'On', I'm not using the virus control software, or connecting it to any DAW. So, it's quite a straight forward, and simple, stand-alone type setup.

When I switch to 'Single' mode, there are no issues with pops, and clicks, but once I switch to 'multi mode', the pops and clicks start becoming audible, especially with long sustain, and release type pad sounds.

I'm currently updated to OS version 3.1.0., but this issue has always been a problem, even with previous OS versions.

This is quite an annoying problem that I have never been able to solve, could this be a HW related issue, meaning, I would need to take my Virus Ti keyboard to an authorized service center ? or could this be a specific setting somewhere, that is causing this ? I have tried various settings to see if I can find out what is causing this, but so far, I still have no clue.

I would appreciate some help/feedback to resolve this issue.

Thanks.

OK Problem Solved !

The cause of the pops and clicks was NOT the Virus Ti, but rather a signal overload issue, due to the gain stages of the Virus Ti signal in my studio setup, signal chain is : (Ti -> PreAmp -> Converter).

I lowered the PreAmp gain/trim knobs, and reduced the overall volume setting of the programs in a the Virus Ti multi, and all is working great, no more pops or clicks.

Virus Ti Sounds Fantastic