sorry if this is wrong but the flashing transpose button means teh Ti is in standby mode, press the transpose button to switch it on.
however if you have been doing this and I have read you wrong then sorry
sorry if this is wrong but the flashing transpose button means teh Ti is in standby mode, press the transpose button to switch it on.
however if you have been doing this and I have read you wrong then sorry
Ok, So my kids are getting out of the way so I can bring the rest of my synths down from the loft. (TI was never allowed up the loft)
I need to upgrade my PC but I need to pick a decent soundcard for my other gear.
I use the TI audio over USB. but I need to connect.
Stereo + MIDI - Korg ER-1
Stereo + MIDI - Korg ES-1
Stereo + MIDI - Korg MS2000 - (I'll pass my analogue synths signal in to this synth as it seems to cancel the noise better?)
Stereo + MIDI - New synth (Always space for another)
I have a Mixer that could take the other Audio and Mix it down, obviously I'd prefer each synth going Directly in.
Where Do I plug my monitors??? Since the TI and Synths will be going in two different cards?
Or do I simply Cheat and plug all my gear in to a mixer and pass it back through the TI??
Whilst my family may not appreciate the advice, I look forward to hearing from you.
Finally got registered to post here,
Hope I can get enough time with my synth to make use of this forum.
Kris
+1 on this one
sounds like the Poly being used up, Unison is heavy on poly, try record a part to audio and retry, Unison is over used as well so see if you can reduce it, if you have 4 voices all with high unison then you might get away with reducing it a bit.
Kris