I'm sure its been discussed before but I wanted to start a thread with the explicit purpose of recreating a JP-80x0 supersaw start-to-finish
It's hard finding samples of the clean supersaw waveform so that the hypersaw can be sufficiently lined up... AFAIK Supersaws are a 7-waveform stack of unknown (possibly close) detune settings.
What comes after that? Thinking a slight LP cut to take the edge off the high end (its really hissy), but I feel like the sound becomes dull too quickly. I also feel like there's a certain hollow/tinniness with the hypersaw on the Virus, though I'm not sure if its my monitors (they tend to dry out most anything played through them) or the Virus itself.
Also what happens after the osc? It sounds really simple, like a reverb and that's it.
Also, does anyone have any good clean samples of a supersaw before postprocessing?