Howdy. brand new user here, but this is the first thing i discovered that I couldn't modulate with the matrix. in the Edit OSC1 page 2/3, when in HyperSaw mode, you can turn on Sync, and use the 3rd Softknob to control the sync frequency. It would be awesome to be able to control this with the matrix. I'm approaching this board after having used kurzweils for about 10 years, so i'm coming with the mindset that any control source can control any destination, and the fact that I can't do this is disappointing. it is such an awesome sound, sweeping the sync frequency! Easy to add from a programming point of view, just add a check to see if we're in hypersaw mode, and if sync is on.
Also, this should be in huge print in the manual:
Zitat-64 to +63: Modulation amount for the specified destination. The range is bipolar so that modulation can be inverted, and amounts are internally doubled so that unipolar destinations can be modulated over their entire range (i.e. 128 values). The Amount itself can be controlled by another modulation source - modulation des- tination is e.g. “Slot4 Amount2”.
I was trying to figure out why the modwheel was modulating the pitch of OSC3 2 octaves when i had it set to +12, OSC3 Pitch in the matrix. As a brand new user, this is counter-intuitive. I expected the pitch to go up 12 semitones when i moved the modwheel, and not 24.
I'm not sure if you guys have access to this, but every time I open Logic, it asks me if I wish to use the Virus as my interface. Perhaps you could add a setting or bit toggle in the driver to disable it as a selectable interface, so i stop being prompted.
regarding the plugin, it would be AWESOME to be able to right-click on any parameter, and select a control-source directly, instead of having to go thru the matrix. It would make programming that much quicker and more efficient.