I've managed to route audio from the host into Virus Control using the "3 Outs / 1 Input" mode. If I select "FX 1 -> Input -> Mode -> Static" I can e.g. use the filter bank to filter the input audio. However, the dry signal is also audible at the same time. In fact, if I select "FX 1 -> Input -> Mode -> Off" the dry signal is still audible. I'm using direct monitoring (the little D button in VC) with audio directly from the Virus output jacks, so it's not caused by sound card mixing. How can I route audio into the effect section without hearing the dry signal?
