controlling Virus parameters over MIDI

    there are a few posts here (one is below) which detail the CC and sysex for the TI
    as there are so many parameters not all are addressable via CC , as it has a limit of 127, hence the need for using sysex (or polypressure depending on control panel setting)

    http://www.virus.info/forum/in…Ex-Virus-TI-Bank-A-D-pdf/


    I think the CC are correct (first column), but i did find some discrepancies in the sysex (other columns)

    thanks for the info and the link... not sure if I ever used sysex for parameter control before with any of my other equipment, I have only ever used it for transferring OS updates etc and only ever used program changes and CC to control parameters/change patches etc on multi FX processors and things like that. Anyway will read that link thank you.

    Just going through the manual and I am up to the section which deals with program changes. The weird thing is in my Virus the 3rd page of the MIDI section of the Edit Config menu does not show. In fact I only have two pages where as in the manual there is a screenshot which clearly shows there is 3/3 page with the Program change enable/disable and multi program change enabled/disabled option. What am I missing?


    Edit: I just realised that it was like that because the Virus VST software was active.


    I also just tried that automating some parameters using that chart, I tried some basic stuff like filter cutoff frequency etc and it worked... the only thing I dont quite understand is what are pages B,C and D for?