Virus Ti2 gives no audio output with ableton live 9

    Hey guys,


    Just bought a virus ti 2 desktop and am dying to using it, but i cannot seem to get any audio from it via live 9!


    ive updated my virus and followed all the install steps and nothing... Ocassionally when i load up the VSTi in ableton the plugin outputs a noise signal at 0 dBfs... Very strange indeed.. The virus also wont run as an audio interface.


    Anyone with experience on this problem please share your thoughts... Thanks!

    Hi Cornelius,
    maybe a bit too simple: check out, where the TI is sendig its audio - usb or normal outputs.
    Next connect your midi keybord directly to the TI and watch if midi goes in correcty.
    Next hook the TI to your PC an have a look at Live's midi-setup, if all port are shown.
    Next route Midi in on Live's channel and audio to master, have a look at your interfaces setup on its output.


    Hope it helps!
    Greetz
    TDP