Using Virus TI Desktop as midi controller for other plugins

vale313 · 9. April 2016

Hey guys,

is there a Way, to use the VirusTI Desktop as a MIDI controller for other VST Plugins (like Largo, Diva, Hive, Nexus) ?

thank you in advance

MrMowgli · 11. April 2016

Shift-Config should be remote mode. Then patch up/down gives you potentially different maps.

vale313 · 13. April 2016

Thanks a lot! This was a good clue.
When I tryed it, I found out that you can't use the multifunction selectons of certain elements e.g. stepping between osc's (of course for remote mode it could be a stepping between any row of knob assignments). If I am right most of the buttons don't even send midi. Is there any solugion/hack to that bescides using multiple templates?

Marc · 13. April 2016

Zitat von vale313

Thanks a lot! This was a good clue.
When I tryed it, I found out that you can't use the multifunction selectons of certain elements e.g. stepping between osc's (of course for remote mode it could be a stepping between any row of knob assignments). If I am right most of the buttons don't even send midi. Is there any solugion/hack to that bescides using multiple templates?

the knobs send MIDI, the buttons don't. there is no way to change that.

MrMowgli · 14. April 2016

Sadly as Marc mentioned the buttons don't send. Perhaps dig through the Feature Request section and +1 the requests that ask for that

Teilen