Hey, my first post here, hope someone can help me out.
I have a Virus TI Snow and it works fine with midi. Today I was trying to get the arpeggiator to work using a guitar through the external inputs, but for the life of me, I couldn't figure it out.
I went to the config menu, made sure that the input had enough sensitivity in the config menu, checked the input thru to see whether there was any signal being input (there was), tried playing around with the common section and had to set the input to static instead of dynamic in order to get sound.
After that I went to the arpeggiator section, but no matter what settings I changed, I could not get the arp to play.
I'd ideally like to do something like this guy in this video:
A more detailed explanation of the setup:
Running a guitar into a Kemper Profiler, then sending a signal of the effected sound through the monitor output into the Virus. Virus is routed to a mixer which sends the signal to my interface to my speakers.
I had the toughest time getting the analog inputs to work with the Virus, the manual makes it sound so easy. "Just plug in". But it took me a long time to figure out that I had to go to the common section for any patch I was playing and set it to "static" instead of "dynamic", besides changing the input to L+R (or R in my case, with only one cable) to even get the Virus to output any sound. Or is that the problem? I mean, should I have set it to "dynamic" instead? But then I get no sound from the virus.
Assuming I've done the right thing, now I would like to get the arpeggiator to work on the Virus. It would be great if someone could help me out here.
I go by nightlight on the Kemper Amps forums too, any users from over there out here?