Posts by Saxatron

I've removed the 6 base plate screws but something is still holding it in place. Do you have to remove the screws holding the I/O connections block?

I'd like to see the Arp number updated when being changed by a controller.

Thanks

Hi Marc

Success! Changing the midi interface worked.

When I tried to install it my Virus C said "" incomplete block Please try again"

Thanx Timo. Not being Format 0 was the problem

I've copied some single buffer sysex dump .mid files (not type 0) to the patches folder but VC doesn't see them. Any suggestions? Thanks

I had a problem which I'd like to mark as "solved" in the title of my post please.

Apologies Marc. It was a system set up error on my part.

Hi,

Installing 3.1 seems to have killed midi reception in TI from Sonar 8.3 (I'm not using VC). I'm going back to 3.03 which was working.

Ah now if it had said "remove power cord, hold config + tap, reconnect power cord and reboot" life would have been easier. Hopefully it now wll be for others.

I use TI + C for trancaphone sax stuff at www.martinsharpe.com

I prefer to control my TI (+ C) with CCs and sysex via midi and not use VC. I'd like to be able to create arps without having to use VC.

I'd just like to see an alert that could be reset telling me the max dsp or voices used since last reset. Then I'd know when to start bouncing. BTW I'd want it in the hardware display not VC as I don't use it.

Holding "Tap and Config" while booting TI did NOT display serial no. only OS. Very awkward to get serial no from base when eyesight is not great and instrument inaccessible. A little more consideration for the user when registering on new site would be much appreciated.