I tried to do this in the matrix and can't seem to figure it out? it should be very simple right?
how to route panning to lfos??
-
-
LFO2 has a pre-configured modulation to "PAN" (panning) set up, which you only need to select and then set the desired value. However you also can use LFO1 or LFO3 for that. Of course you can also set this up in the "MATRIX" by using LFO1, LFO2 or LFO3 as the Modulation Source and then "Panorama" as the Modulation destination. Of course you need to select also a value on how strong the modulation should be.
Best wishes,
Jörg Hüttner -
thanks,
that helps loads