It seems that I've found a bug in OS 4.0.5.01, I'm not sure if it was present in previous versions.
The stored value of a parameter which is indicated in brackets is not correct when you switch from multi mode to sequencer mode and then back to multi mode.
For example, starting with the TI rebooted and freshly powered on:
Enter multi mode. Pick patch on channel 1 : ROM-A 6 BellfireBC via the search function
Turn the attack knob, you will see [ 0 ] in the brackets properly indicating the attack in the stored patch is 0.
Pick another patch, like a pad with a long attack. For example ROM-A 17 ChoirBelBC which has an attack of [ 104 ] and it's shown properly.
Now, enter sequence mode, and go back into multi mode.
You will find that every patch you listen to in multi mode from now on will show the stored parameter in brackets of the patch that was previously selected in sequence mode. In my case, ROM-A 0 init. The example ROM-A 17 pad patch will show a stored attack of [ 0 ].
This behavior seems to continue until the power is reset on the TI.
Could someone at access try this to confirm?
thanks
Rob