Multi Mode Problem

    I have a strange sound/patch that pop up in Multi Mode


    I am a new owner of Virus Ti and have problem to find answer to this question anywhere.


    After "shift+Edit" in MultiMode there is a default sound/patch when press a key, yet the text -init- is everywhere.


    When more sounds/patches has been added this default sound/patch is still there also.


    How to disable this deafult sound/patch in Multi Mode ?
    or
    How to change this deafult sound/patch to another sound/patch Multi Mode ?
    or
    Is it some oscillator/signal that interfer somehow ?



    This same thing happens in Firmware 4 and updated 5.03



    Thankfull for help


    Best regards / Lasse

    It is possible to disable the separate parts, so the ones you are not using do not interfere. When in the config menu use the < PARAMETERS > buttons to navigate to the page that allows this. Use the < PART > buttons to go over all the parts and decide which to enable and which to disable. IIRC on the same page you can set the MIDI channel to respond to so that you can make more than one part play at once.
    Hope this helps.

    Thanks for your help and suggestion.


    I also found another solution, copy a fully working MiltModePatch and rename it, then change singel patches to the desired ones, then it sound good without interfering sounds.



    Best regards / Lasse