Last night I was trying to add some distortion to atomized sounds using the VC plugin.
When I turn up the mix knob all that happens is that the volume of the patch fades out - no distortion at all.
Can anyone else reproduce this behaviour? I was under the impression that ALL effects work with Atomizer.
I'll have a shot again tonight without VC and report back.
What freq would the patch be when it fades out?
Distortion works well at low - mid freq, but not high as much.
Also, there is no matrix with patch mix/volume involved, is there?
What freq would the patch be when it fades out?
Distortion works well at low - mid freq, but not high as much.
Also, there is no matrix with patch mix/volume involved, is there?
No audible frequency, or amplitude.
There's no sound at all when I turn the mix knob to 100% and no distortion seems to be applied to the atomized signal. Tried multiple dist modes too.
Pretty sure I was using an init patch so I don't think the mod matrix would be causing the issue.
Do you get similar behaviour?
Thanks for the reply.
It will be a while until I get a chance to test this, but did you try the distortion from the saturation module of the filter section?
It will be a while until I get a chance to test this, but did you try the distortion from the saturation module of the filter section?
Hi flabberbob,
That did not cross my mind. I'll have a go and report back.
Cheers
No dice using the saturation module in the filter section either.
Can anyone at Access reproduce this behaviour?
