Hi there,
I've connected a stereo synth to input 1 and 2 of a TI2.
The 2 incoming signals (L/R), seem to converted to one mono signal, because I can't pan the individual input signals to left and right.
To fix this I've divided the signals over 2 parts in the Virus Control plugin. So input L is routed through part 1 and input R is routed through part 2. Now I can pan both parts to resp. left and right and I have my stereo signal, yay!
This works fine for me, the problems start when I want to automate, lets say, the cutoff, for the input signal. I have them splitted over two parts, so I have to automate the signal twice, for left and right. This is not very convenient.
To fix this problem, I would like to set the midi channel for both parts to the same channel, that way I can send automation to ie channel 1 and both channels will recieve the midi message.I know it is possible to set the midi channel per part in multi mode, without using the Virus Control plugin, but I can't seem to find the midi channel setting for the parts in the VC plugin.
- How can I set the midi channel for the parts using sequencer mode/vc plugin?
- Is there another, better way to get my stereo signal nicely panned through the virus?
Thanks for your time and effort!
spdk