Ability to vary data parameter display based on Value knob speed

SynthMan65 · 23. März 2013

This has probably been brought up, but I'd like to have it where if I turn a Value knob slowly, the data in the display would increase / decrease accordingly, maybe using some exponential algorithm.

So if you turn the know slow, the data choices only happen about every 1/8th of a turn, but if you turn the knob quickly then it increases to 1:1 or faster.

flabberbob · 24. März 2013

This might work for endless rotary encoders, but with knobs which have a fixed range of motion, it might make you lose the sense of position. Besides, with all controls (pitch bend being an exception) having 7 bit resolution (128 values), an increase in knob resolution can do very little.

Teilen