"Hypersaw Local Detune" (via the PWM parameter) cannot be assigned to soft knobs in TI plugin, but can be assigned on the panel. This appears to be a bug with the plugin. Any advice?
BUG REPORT: "Hypersaw Local Detune" cannot be assigned to soft knobs
-
-
Any advice?
Stick with the panel?
-
Stick with the panel?
I suppose I should have seen that coming.
After reading this forum and researching the current state of Virus software development it appears that Kemper/Access may have abandoned the TI2 keyboard? I've wanted one for about a decade and finally decided it was time. Kind of frustrating, like showing up to a concert as the encore is ending but you grab a CD at the merch table anyway because what the heck.
Its not a major issue by any means though, and I am really enjoying the keyboard because its super intuitive to program and sounds great. I have no regrets.
-
I suppose I should have seen that coming.
Sorry, couldn't resist! All in good fun though! Everyone here probably knows by now I'm a hardware-only old-schooler (but not just analog, of course). Welcome to the forum!
I am really enjoying the keyboard because its super intuitive to program and sounds great. I have no regrets.
Quite the synth, isn't it? I'm blown away every time I pull up ROM patch D32 DustFld, among some other favs.
Hey, if the Classic Osc mode Spectral Wave bank interests you be sure to check this thread out:
Essay: Spectral Wave Explorations
Currently I'm working on a project trying to put the TI2's 100 wavetables into some kind of categorization to make a user-friendly chart to help with 'table selection. I'll post when ready.
Cheers!
-
"Hypersaw Local Detune" (via the PWM parameter) cannot be assigned to soft knobs in TI plugin, but can be assigned on the panel. This appears to be a bug with the plugin. Any advice?
Interesting find! Gotta check that and see whether this applies to other parameters which cannot be assigned within the plugin as well.