I've only noticed this since I loaded OS5. I have a TI2 whiteout 61 key.
The LED's that show the rate on LFO's 2 and 3 work perfectly, but the LED on LFO 1 only shows the rate that the LFO was cycling when the patch was loaded. In other words: When you recall the patch the LFO 1 LED shows the correct rate. But if you change it's rate or the waveform type, the LED doesn't change. It stays the same as when the patch was loaded.
The good thing is the actual speed of LFO 1 does change, I can hear the change in effect on it's destination. But the LED does not display the new rate.
It's a little off-putting because I do most of my editing via the hardware so I like to see the feedback of the LED changing to reflect the LFO setting.
Let me know if anyone else has the same problem, or if it is OK on other units.
Stuart.