Thanks Marc,you too have a nice holiday and wish you all the best.
Posts by heckmat
-
-
Go to config page and select 3 out.
-
There are many ways
start with simple oscillator like sine and try to animate your sound in matrix section and select different parameters and value like lfo,rate,fxs, and ....
also take a look on virus boot camp page there are many useful video. -
Congrats;
-
if you're using standalone mode just press multi button .
for selecting parts you have to press < parts > button . -
is it recognized as a unknown device ?
-
MMatthews ,Marc is right , if you share your patches sound in your project then i would be glad to play them in my project..
-
1-open virus control go to config panel set 3 output/no input
2-press F11 ,click the arrow icon on the left of virus ti and select all 3 channel -
you can only load one virus control in your plugin list at the same time..for using other usb channel or multitimbral parts please read the references manual..
-
-
Virus Control Multi Part Save and Export Plus Importing the Parts and Automation the parts From old project..
-
1-create midi track
2-route them (midi out) to each virus ti midi channel (1,2,3)
3-automate them.. -
to insert extra effects you would be able to use 3 usb out from your virus and you can enable those channel from vst instrument panel.
-
[quote='AtonyB',index.php?page=Thread&postID=13705#post13705][quote='heckmat',index.php?page=Thread&postID=13691#post13691]also ti use 2 dsp ,one chip for odd channel(1,3,5,..) and one chip for even channel (2,4,6,...)
marc still didn't confirm it but it discussed many times in forum ..
i don't think ti sum and output all parts by 2 dsp in the same time and also they didn't use reverb and delay as a master fx and i suppose 1 chip isn't enough to handle all 16 parts they added 2 dsp chip and it seems these chip have their independent calculation.. -
try disconnect all your usb devices then remove all cables from your virus except of power plug then press arp edit button for 10 seconds and then release it,after that your virus will turn on and then connect the usb cable ..
-
it seems ti use different algorithm to apply effects ..
but it would be nice and also decrease dsp usage .. -
did windows show you (not recognized device) or ????
-
also ti use 2 dsp ,one chip for odd channel(1,3,5,..) and one chip for even channel (2,4,6,...)
-
in ableton first go to the VC config and select 3output or 2...
then create 2 audio track and change the input track to virus 2 and 3 and then turn on the monitor... -
not sure ,probably soundiver need midi in/out together to connect your virus.
what about your keyboard does it have usb connection?
or connect it to slot b of your midi interface.